Mounting And Removing Flat Panel Screen - PEERLESS Mounts EPMU-05 Installation Et Assemblage

Mounting and Removing Flat Panel Screen

WARNING
• Always use an assistant or mechanical lifting equip-
ment to safely lift and position the fl at panel screen.
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
• Be careful not to pinch fi ngers when pushing screen
from the bottom.
Mounting Screen: Hook tilt brackets (H,I) onto
3
adapter plate (E) and swing screen in as shown
in fi g. 3.1. NOTE: If the security clip does not
clear the bottom of the adapter plate, loosen the
security screw with allen wrench (J). Tilt bracket
hooks must fully engage adapter plate as shown in
detail 1. Tighten security screw using allen wrench
(J) until security clip sits fi rmly against bottom of
adapter plate.
NOTE: Be sure security clip is secured to bottom
of adapter plate as shown in detail 2.
Removing Screen: Loosen security screw from
security clip until the screen is able to swing freely,
and lift screen off of mount.
Screen Adjustment: Screen can be adjusted
horizontally by loosening security screw three full
turns using allen wrench (J). Adjust screen as
shown in fi gure 3.2. Tighten security screw.
Adjusting the Tilt Angle of the Flat Panel
Screen
NOTE: Choosing and setting tilt position may be
4
easier before placing screen onto wall mount.
INCRELOK™: The screen can be locked into a
pre-set tilt position of -5°, 0°, 5°, 10° or 15°. Use
locator hole to fi nd tilt position hole and tilt screen
to align holes. Tighten IncreLok™ tilt screws on
both tilt brackets as shown in detail 3.
Tighten locking screw to lock down tilt position.
fi g 3.1
7 of 32
ISSUED: 06-22-10 SHEET #: 061-9053-6 01-15-11
All other brand and product names are trademarks or registered trademarks of their respective owners.
H,I
DETAIL 1
E
SECURITY
SCREW
SECURITY
DETAIL 2
fi g 3.2
IncreLok™
TILT
SCREW
LOCATOR
HOLE
LOCKING
SCREW
DETAIL 3
fi g 4.1
© 2010, Peerless Industries, Inc. All rights reserved.
CLIP
TILT
POSITION
HOLES