Publicité
Les langues disponibles
Les langues disponibles
1.
Remove the battery earth cable.
Remove the covering in the boot.
Clear the entrance to the right rearlight unit.
2.
Drill a 13 mm large hole underneath the right rearlight unit.
Carefully remove all metal particles and threat the edges with an anti-corrosion paint.
Put the rubber grommet in the hole.
3.
Route the wiring harness in the boot.
Lead the 8-pole end through the grommet to the socket.
Pull the rubber coverplate over the wiring harness.
Remove the contactholder from the socket and fit the wires as indicated:
Trailer lighting:
Left turn signal
Rearfoglight
Earth
Right turn signal
Right taillight
Brakelights
Left taillight
Rearfoglight
Mount the socket to the towbar.
4.
Near the right rearlight unit a 10-pole connector is located.
Disconnect this connector and connect the wiring harnesses connector with the grey, green, yellow, brown, black, blue en red wire between this
connector.
Fit the white wire to chassis earth.
5.
Reconnect the battery and check all electric functions, with trailer/caravan connected.
Reinstall disassembled parts.
©ECS1999
FITTING INSTRUCTIONS ELECTRIC WIRINGKIT TOWBAR WITH 12-N SOCKET UP TO
DIN/ISO NORM 1724
PEUGEOT 306 hatchback 1993-1997
306 saloon/cabriolet 1994-1997
Partno.: PEU-014-B
Pin No.:
Wire colour:
1 (L)
yellow
2 (54-G)
blue
3 (31)
white 2,5 mm2
4 (R)
green
5 (58-R)
brown
6 (54)
red
7 (58-L)
black
8 (58-b)
grey
PEU-014-B-E
191199L
1
8
STOP
2
6
7
3
5
4
REVISIE 0
Publicité
