ARANI EX-BA3-275W-V1 Installation

PLEASE READ ALL INSTRUCTIONS BEFORE ATTEMPTING INSTALLATION
— To prevent personal injury or product damage only licensed electricians should install.
— To avoid electric shock or component damage disconnect power before attempting installation or servicing.
— Battery acid can cause burns to the skin and eyes. If acid comes in contact with the skin or the eyes, rinse a ected area with water and contact a doctor immediately.
— This product must be installed in accordance with the national electric code (NEC) and all applicable federal, state and local electric codes and safety standards.
— This product is not waterproof - install indoors only.
— Do not install close to heaters of any sort.
— Any alteration or modi cation of this product is expressly forbidden as it may cause serious personal injury, death, property damage and/or product malfunction.
— To prevent product malfunction and/or electrical shock this product must be properly grounded.
— This luminaire is designed to operate in ambient temperatures ranging from 15°C to 30°C.
INSTALLATION - EX-BA3-275W-V1
WARNING
Red (+)
Black (-)
Battery
12V/12AH
Tilt
Head
Driver
LED Display
Green: main
Test
Visible Window
Battery 12V/12Ah
AC120V 50/60Hz
GREEN LED
TEST
AC347V 50/60Hz
(AC ON)
INPUT CABLE
MAIN PCBA
RED AC347V (L1)
FUSE
BLACK AC120V (L2)
WHITE (N)
DRIVER
GREEN (E/G)
AC WIRING
Rotate 180°
Circuit Board
Battery 12V/12Ah
Battery Fixing Clip
Cover
HEAD
HEAD 1 HEAD 2
HEAD n
OUTPUT:
DC 12V
RED +
BLACK
OUTPUT LOAD
HEAD
12V / 12AH
2×5W 265W
271W
2×2W
12V 12AH
BATTERY