Mechanical Characteristics - Uniteck UNISENSOR Mode D'emploi

CAUTION
!
Connect the sensor to the battery respecting
REMOTE VOLTAGE AND TEMPERATURE SENSOR
S
YSTÈME
Battery voltage
Self-consumption
Protection rating
Maximum cable section
Altitude max

MECHANICAL CHARACTERISTICS

Dimensions (LxHxW)
Weight (without cables)
Operating temperature
Storage temperature
When connecting, the polarities must be observed.
Reverse polarity can cause irreversible damage to your UNIMPPT charge controller.
Damage not covered by warranty.

the polarities
Check that the green light on the sensor is on. In this case,
If the yellow light is on, check and change
the wiring until the green light comes on
UNISENSOR
-20°C à + 60°C
-30°C à +80°C
www.uniteck.fr

you can continue the installation.
12/24V
1 mA
IP X0
1,5 mm²
2500 m
52 x 37 x 25
25g
EN
5/7