Remote Control Icontrol (Option) En; Mains Connection; Operation - Binzel IROB P400 Mode D'emploi

7 Operation

6.4.1 Remote control
iCONTROL
The remote control iCONTROL is designed exclusively for the robot welding power source iROB and is
used for setup and paramter setting
For mounting, observe the information given in the operating instructions BAL.0333.0 iCONTROL
1 Insert control lead iCONTROL into the connecting socket (8).
 Fig. 7 on page EN-17

6.4.2 Mains connection

Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
Personal injuries and material damage
Incorrect mains connection can result in personal injuries and material damage.
• Mount the components only with the mains plug pulled.
• Check whether the system used is earthed.
• Connect the system only to the sockets which have protective earthing conductor.
• Have defective and damaged mains connection repaired by a qualified specialist (in Germany see
Risk of injury
Limbs can be crushed and cut.
• Use an appropriate lifting tool with load securing devices for transport and installation.
1 Plug the mains plug into the corresponding socket.
7 Operation
NOTICE
• The device may only be operated by qualified personnel (in Germany see TRBS 1203).
• Please observe the operating instructions of the welding components, coolant recirculator iCOOL
The robot welding power source can only be put into operation in connection with the complete robot
welding system iROB.
EN - 16
(option)
DANGER
DANGER
TRBS 1203).
WARNING
(option), wire feeder iFEED (option), remote control iCONTROL (option) and welding torch.
iROB