Summit Treestands Watchtower Mode D'emploi page 11

12' LEG ASSEMBLY / LEG BRACES
36
3 3/4" BOLT, LOCK NUT,
WRENCH TIGHTEN
37
BRACKET
(PN 82073.1300)
39
2 3/4" BOLT, LOCK NUT,
41
WRENCH TIGHTEN
COUPLER
PLATE
(PN 82073.1000)
BRACKET
(PN 82073.1300)
1. Carefully lay the completed top section on its side - ladder rungs
up as shown in figure 36.
2. Position one of the Coupler Plates as shown in figure 37. Slide
the plate over the leg, between the Upper Ladder Assembly and line
up the holes. NOTE: Coupler Plate must line up with the round
holes and not the oval holes.
3. Position one of the Brackets as shown in figure 38. The bracket
should be bolted to the Coupler Plate so that it runs horizontally
when the tripod is sitting upright.
4. Use one
Coupler Plate.
5. Position the 72" Ladder Assembly as shown in figure 39.
6. Slide the Assembly into the Coupler Plate and secure with one,
3/4" bolt and lock nut.
72" LADDER
ASSEMBLY
(PN 82073.1100)
7. Carefully rotate the tripod assembly to gain access to one of the
legs.
8. Slide another Coupler Plate on the Leg and line up the round
holes as shown in figure 41.
9. Position one Bracket as shown in figure 41 and secure using one
3/4" bolt and lock nut.
Hardware Needed
5/16"-18 - 2 3/4" Bolt - 8
5/16"-18 - 3 3/4" Bolt - 1
5/16"-18 - Lock Nuts - 9
3 3/4" bolt and lock nut
38
(see figure 40)
2 3/4" BOLT, LOCK NUT,
WRENCH TIGHTEN
40
1/4"-20 - 1 1/2" Bolt - 12
1/4"-20 - Lock Nuts - 12
to secure both the Bracket and
COUPLER
PLATE
(PN 82073.1000)
PG 11
2
2