Goodwe LAN Kit Guide D'installation Rapide page 4

Quick Installation Guide V1.2-2022-11-10
Power On
03
Step 1 Make sure that the inverter is powered on.
Step 2 Make sure that the router or the switch is powered on.
Commissioning
04
Step 1 Connect the computer and the LAN module using a network cable.
Step 2 Enter 169.254.1.1 in the browser. User name: admin; password: admin. Set the
F
parameters as shown below.
Advanced
Management
Account
No. Parameters
1 IP DHCP Mode
IP address
Subnet Mask address
2
Gateway address
DNS Server address
Access point setting
Firmware version
MAC address
DHCP setting for STA
Note: After changing the settings, the device must be restarted.
Description
• Select DHCP when the router is in dynamic IP mode.
• Select STATIC when a switch is used or when the router
is in static IP mode.
• Do not configure the parameters when IP DHCP Mode
is DHCP.
• Configure the parameters according to the router or
switch information when IP DHCP Mode is STATIC.
V 1.0.14
F0FE6BBA21AE
1
STATIC
2
***.***.***.***
***.***.***.***
***.***.***.***
***.***.***.***
3
3
Save