Hella 2XD 959 073-60 Serie Instructions De Montage

Fitting Instructions for
Warning
Part Number: 2XD 959 073-60x - Blue 12V
2XD 959 073-65x - Blue 24V
2XD 959 073-70x - Red 12V
2XD 959 073-75x - Red 2
Included in the kit is:-
2 Black Stainless Steel Screws
1 Lamp with 2.5 Metre Cable
1.0 MOUNTING
Determine mounting position and holes as per the diagram below. (Before fitment see
2.0 WIRING on reverse)
Fit lamp to mounting aperture with the screws provided.
Fit screw caps.
Note:
Do not overtighten mounting screws in lens.
If it is necessary to remove the screw caps, lever them out with a pin.
LED
Lamp
4V
2 Clear Screw Caps
2 Black Screw Caps
2.0 WIRING
Due to the advanced LED technology employed in the manufacture of this Warning LED Lamp, some
additional care must be taken while wiring this unit.
The LED Lamp is polarity conscious, that is, unless the lamp is correctly connected it will not function. The
RED cable must be connected to POSITIVE (+).
As almost all circuit applications are Negative Earth, we have written these instructions to suit.
Disconnect battery NEGATIVE (-) terminal. Run cable to existing wiring harness, if possible where other
cables already run. Make sure that the cable insulation is not damaged by sharp edges.
Connect the RED cable to the existing cable POSITIVE (+), and the BLACK cable to a suitable earth
NEGATIVE (-).
Reconnect battery NEGATIVE (-) terminal.
Wire Colour Connect to
Red Positive
Black Negative
NB: Lamp must be protected by a fuse rated at 2 amperes maximum.
Notes: Applied voltage above the following limits will damage the internal LED's:-
12V lamp - 16V continuous
24V lamp - 30V continuous
FIT AND FORGET - BY DESIGN
Congratulations!
The product you have selected comes from HELLA - a world leader in LED
lighting design.
Following the launch of the first LED automotive signal lamps in 1990, HELLA Design and Innovation continues to set
new standards. HELLA innovative solutions have been incorporated into millions of lamps, engineered and tested to
the most demanding standards, to suit the harshest environmental conditions.
The corner stone of the success of our products is our no compromise "Fit and Forget - by Design" philosophy which is
incorporated into every step of the product life cycle.
In a world consuming finite resources at an ever increasing rate, Fit and Forget –by Design is the right environmental
choice that also makes economic sense for our customers that consider the total life cycle Cost of Ownership.
For general comments about HELLA's products please contact us on E-mail at techfeedback@hella.co.nz
Power Consumption
Less than 2 watts
-