Satco 62-632 Guide De Montage Et D'assemblage

ASSEMBLY AND MOUNTING INSTRUCTIONS
PLEASE READ THE ASSEMBLY INSTRUCTION SHEET CAREFULLY BEFORE PROCEEDING. Carefully unpack
and identify all parts prior to building the unit. Each part is identified on the drawing for reference.
DO NOT DISCARD THE ORIGINAL PACKAGING. If after careful inspection, you must return the item for any
reason. Please repack the unit using the original carton and inserts.
STEP 1: Unpack all the parts and classify them according
to the illustration shown at the side. Place the parts on a
scratch free surface.
STEP 2: Install the glass using the socket ring.
STEP 3: Install the correct bulb (provided).
STEP 4: Make sure the power is turned off at the wall outlet
box where the fixture is to be installed. Secure the mounting
bar to the wall junction box using the mounting screws.
CAUTION:
To reduce the risk of fire, use the specified lamp wattage (or smaller) and bulb type identified on the product.
CLEANING INSTRUCTIONS:
Do not use polish or cleaners on your product. Just wipe clean with a soft cloth.
CAUTION – RISK OF FIRE
This product requires installation by a qualified electrician. Before installing be sure to read all instructions
and TURN THE POWER TO THE ELECTRICAL JUNCTION BOX OFF.
ITEM NO: 62-632, 62-637
ITEM NO: 62-632, 62-637
ARTÍCULO Nº: 62-632, 62-637
ARTICLE N°: 62-632, 62-637
STEP 5: Use the wire connection to connect the positive
and neutral wires. Connect the ground wire to the junction
box ground port.
STEP 6: Secure the fixture to the wall outlet box using
the finial.
Turn on the power at fuse or circuit box.