Table des Matières
Publicité
INDEX:
1. INTRODUCTION
1.1 CONTENTS
1.2 FEATURES
1.3 RECOMMANDATIONS
3.2.3 Remote Control
3.3 CLEAR ACCESSORIES
4. ENTER SETUP DATE
4.1 PROGRAM RINGING TIME OF THE SIREN
4.2 PROGRAM EXIT DELAY & ENTRY DELAY
4.3 ENABLE REMOTE PHONE CONTROL
4.4 DISABLE REMOTE PHONE CONTROL
4.5 CHANGE PASSWORD
4.6 RESTORE DEFAULT SETTINGS
4.7 STORE PHONE NUMBERS
4.8 DELETE PHONE NUMBERS
4.9 EXIT SETUP STATE
4.10 ALARM RESPONSE WHEN BEING OUT OF HOME
4.11 REMOTE PHONE CONTROL
4.12 PROGRAM USER NUMBER FOR CMS
4.13 UPLOADING ARM/DISARM REPORT
5. OPTIONNAL ACCESSORIES LIST (not included)
6. PROGRAM LIST
7. PHONE REMOTE CONTROL INSTRUCTION
8. SPECIFICATIONS
1
1.INTRODUCTION
Thank you for choosing the system wireless security SIGMATEK SSA-8.
Please read this manual carefully to get the best experience with this product. All
customization procedures are described here and this manual will answer all your
questions.
Keep this manual for future reference.
1.1 CONTENTS
- 1 x Control Panel (Internal Siren/ Rescue Battery)
- 2 x Remote Controls
- 2 x Wireless Motion Detectors
- 2 x Wireless Window/Door Contacts
- 1 x AC Adaptor
- 1 x 500mAh battery
1.2 FEATURES
- System alarm security complete and fully wireless.
- Easy installation
- Access by phone remote control
- Built-in 1,000,000 RF codes combination maintains high reliability.
- Simple accessory expansion by automatic recoding
- Included 2 remotes control.
- Built-in 110dB siren, deterring intruder on site
- Store 6 alarm phone numbers and 2 ADEMCO CID CMS numbers.
- Simple operation by voice prompt menu
- Remote arm, disarm and monitor by phone operation
- Built-in 500mAh lithium battery, enables 8-hour standby
1.3 RECOMMANDATIONS:
For your safety, keep certain precautions:
- Do not forget to arm your control panel during your absence, making sure it
works properly.
- Do not forget to lock the doors, windows and other issues of your home.
- Always keep your remote safely with you and do not leave it visible or noti-
ceable.
- To optimize the operation of the alarm system, it is recommended to choose the
best location to install each accessory.
- For each accessory, it is recommended to choose a location with a good wall
surface so that tampers tear are effective.
- Alarm accessories purchased separately must be connected to the control panel
manually.
- Do not close immediately the cover of your detector before the end of the test.
- If you don't use this product for a long time, remove the batteries to avoid
overconsumption.
- Be careful to damage the detector when opening the door.
- Do not cross the beams of different motion detectors.
2
- Liens rapides:
- Installation des Accessoires
Hide quick links:
Publicité
Table des Matières
