Dorman 902-670 Manuel D'instructions

INSTRUCTIONS
ENGINE WATER
PUMP HOUSING
902-670
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact vehicle
configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2022 No reproduction in whole or in part without prior written approval.
902-670_Instructions
2
4
3
1 Water Pump
2 O-Ring
3 Bolts
4 Engine Oil Cooler-to-Water
Pump Connector
REMOVAL
INSTRUCTIONS
STEP 1:
Drain coolant. Remove small coolant pipe.
STEP 2:
Disconnect and remove throttle valve
control module.
STEP 3:
Remove water pump belt.
STEP 4:
Remove nut and bolt securing intake
manifold support.
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible
circumstances or situations. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
1
5
5 Thermostat
6 Gasket
7 Cover
8 O-Ring
STEP 5:
Remove bonded rubber bushing from intake
manifold support.
STEP 6:
If equipped, disconnect connector from
map-controlled thermostat.
STEP 7:
Remove engine coolant temperature sensor.
STEP 8:
Remove five bolts attaching water pump
and remove water pump.
PAGE 1 OF 6
8
7
6