Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75516F
Wrenches: 19mm
Drill Bits: None
Frame Rail
Exhaust
1
Qty. (4)
M12 X 1.50 X 40mm CL 10.9 Hex Bolt
Spare tire may need to be lowered for installation.
1.
Raise receiver over exhaust and into position between vehicle frame rails.
2.
Install M12 X 1.50 Hex bolts and conical toothed washers into existing weldnuts.
Tighten all M12 X 1.50 CL10.9 fasteners with torque wrench to 92 Lb.-Ft. (125 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2006 Cequent Towing Products
Installation Instructions
Kia Sorento
Fascia
Weight Distributing
Wiring Access Location: SUV7
2
Sheet 1 of 3
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Max Gross
Hitch type
Trailer WT (LB)
5000 (2268 Kg)
Weight Carrying
5000 (2268 Kg)
Ball Mount
Frame Rail
Qty. (4)
Conical Toothed Washer
75516N
Part Numbers:
75516
87425
44558
Max Tongue
WT (LB)
500 (227 Kg)
500 (227 Kg)
9-22-06
Rev. A
Form: F205 Rev A 5-6-05
Publicité
Manuels Connexes pour Cequent Towing Products 75516
Sommaire des Matières pour Cequent Towing Products 75516
- Page 1 This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. Sheet 1 of 3 75516N 9-22-06 Rev. A 2006 Cequent Towing Products Form: F205 Rev A 5-6-05...
- Page 2 Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage. Feuille 2 de 3 75516N 9-22-06 Rev. A 2006 Cequent Towing Products Form: F205 Rev A 5-6-05...
- Page 3 Este producto cumple con las especificaciones y requisitos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York, V.E.S.C. Regulación V-5 y SAE J684 Hoja 3 de 3 75516N 9-22-06 Rev. A 2006 Cequent Towing Products Form: F205 Rev A 5-6-05...