Publicité
Les langues disponibles
Les langues disponibles
10. Ensure the trim piece at the leading edge of the hood is clean and dry. Wipe with an automotive surface cleaner and dry with a soft
cloth or paper towel. Before removing the protective liner, center the 55 length of D gasket on the trim piece to determine where it will
be located. It should be centered and sit at the very back edge of the trim, right against the hood. See illustration. Once the location is
determined, remove the protective liner and carefully lay the D gasket in place. ***TIP*** Peel only a small length of the backing
and lay the end of the D gasket in place, then peel and stick as you move down the length of the gasket. Wet out the gasket
from one end to the other to ensure it is adhered properly to the surface.
11. Place the hood protector on the hood and fasten the four (4) # 8 x 7/16 wafer head screws through the protector and into the
expansion plugs. Do not over-tighten.
12. Peel an anti-abrasion film pad from the backing and fold it over the edge of the hood, centered underneath the holes (one each side)
in the protector in the area over the headlights. See Illustration
13. a) Place a clip over each of the anti-abrasion film pads on the edge of the hood as shown in Illustration
b) Insert a pin through the protector into each of the clips. See Illustration
c) Insert a #6 x 5/8 screw through an L - bracket and into the clip. See Illustration
d) Ensure all the components are well seated together and the protector is still centered on the hood, then tighten the screws into the
clips.
Clip Configuration
- Patent No. 6,892,427
Step #12
On some vehicles it may be necessary to adjust the hood bumpers and/or latch for proper clearance.
Note: Do not pull on the protector when opening or closing the hood.
Care Instruction
Clean the protector with a mild soap and water solution or plastic cleaner only. Do not use chemicals or solvents. Periodically
check to make sure that the hardware is in place and that the protector is secure. Avoid using automatic car washes. Do not pull on
the protector when opening or closing the hood.
Thank you for purchasing a hood protector. Retain this sheet for care instructions and kit information.
Step #13a
Step #12.
Step 13b.
Step 13c & 13d.
Step #13b
Step 13a.
Step #13c & 13d
Rev0.Oct 21, 2015
Page 3 of 6
Publicité
