Operation - Bartscher TKS32 Mode D'emploi

•
Place the device in such a manner that there is a minimum of 10 cm between it and
other objects, including walls, in order to ensure proper air circulation.
•
Do not place the device where humidity or temperature are high as the device may
be damaged.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.

5.3 Operation

•
Prior to first use, wash the device with warm water and a delicate cleaning agent.
Wipe with clean water, then dry thoroughly.
•
Connect the device to an appropriate single outlet.
Temperature regulation
•
The temperature may be set using the temperature dial. It is located at the rear of
the device, on the inside wall.
•
To set the temperature, turn the dial clockwise to the desired temperature.
• „MIN", „NORMAL", „MAX" and „OFF" show the
different temperature settings.
• „MIN" is the highest setting, „MAX" the lowest.
• For normal use, it is recommended to set the
temperature at „NORMAL". Other settings may
be used if „NORMAL" is too warm or cool.
•
To disconnect the device, set the dial to the position marked „OFF".
•
Prior to first use or following defrosting, set the temperature to the „MAX" position at
least 2 hours prior to inserting products or drinks into the freezer.
•
Next, set the desired temperature.
- 23 -