Salton SGS2 Instructions Et Garantie page 4

INSTRUCTIONS FOR USE
 Turn the gas supply ON (anticlockwise )
one and half turns at the cylinder control
valve.

Push the control knob inwards and turn it
anticlockwise  until you hear the ignition
click. Check that the burner is lit. If the
burner is not lit, turn the control knob back
to the off position and repeat the
aforementioned procedure.

Reduce the flame size by turning the
control knob anticlockwise .

If the burners do not burn properly, it may be necessary to adjust the air dampers.
These are located under the control knobs, underneath the stove body. Adjust the
dampers until the flames are steady with a rounded core as shown in Fig. X.
 To turn the burners off, turn the control knob clockwise to the "Off" position and
ensure that the flames have been
extinguished. Close the cylinder valve by
turning it clockwise.
4