Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
COS-ADP
INSTALLATION INSTRUCTIONS
1. Take all of the wires from the ceiling mounted
occupancy sensor and carefully run them
through the threaded nipple of the adapter.
2. Align the two mounting tabs on the adapter
into the two "L" shaped slots on the occupancy
sensor.
3. Twist the adapter counterclockwise about 1/4"
with respect to the sensor until the two are
comfortably locked together.
4. To remove the adapter (if needed), firmly
grasp the two pieces together and twist the
adapter clockwise about 1/4" until the two
pieces separate. Do not force it.
CAUTION
We recommend that installation be made by a liscensed electrician.
Before wiring and servicing, power to this unit and the equipment it controls must be turned off at the
main panel.
Connect in accordance with national and local electrical codes.
LC-1014 (A)
www.nsiindustries.com
Publicité
Sommaire des Matières pour NSi INDUSTRIES TORK COS-ADP
- Page 1 COS-ADP INSTALLATION INSTRUCTIONS 1. Take all of the wires from the ceiling mounted occupancy sensor and carefully run them through the threaded nipple of the adapter. 2. Align the two mounting tabs on the adapter into the two “L” shaped slots on the occupancy sensor.
- Page 2 COS-ADP INSTRUCTIONS D'INSTALLATION 1. Prenez tous les fils du détecteur de présence installé au plafond et faites-les passer délicate- ment à travers la tige filetée de l’adaptateur. 2. Alignez et insérez les deux onglets de fixation de l’adaptateur dans les deux fentes en « L » du détecteur de présence.
- Page 3 COS-ADP INSTRUCCIONES DE INSTALACIÓN 1. Tome todos los cables desde el sensor de ocu- pación montado en el techo y tiéndalos cuidadosamente a través del niple roscado del adaptador. 2. Alinee las dos lengüetas de montaje del adap- tador en las dos ranuras con forma de “L” que tiene el sensor de ocupación.