Velleman KNS3 ROBOMECH Manuel D'instructions page 2

3. Prepunched Boards
4. Assembly
The gears (P4-7) should be placed to the left of the pinion gear (P3). Put one N-shaped nylon connector (P12)
downward and another one upward. Note that the protruding edge should point towards the metal case.
Screw a fixing plate P29 to boards B and C and fix them to board A. Then screw the gearbox onto board A.
KNS3
Fig.2
Fig.3
Fig.4
- 2 - VELLEMAN