ARTHUR MARTIN AC2200AOW2 Notice D'utilisation page 10

10
Problem
Power indicator light is flash‐
ing.
The lid doesn't close com‐
pletely.
The lid is difficult to open.
The lamp does not work.
The compressor operates
continually.
There is too much frost and
ice.
The temperature in the ap‐
pliance is too low/too high.
All manuals and user guides at all-guides.com
Possible cause
An error has occurred in
measuring the temperature
or the appliance is not work‐
ing properly.
Food packages are blocking
the lid.
There is excessive frost.
The lid gaskets are dirty or
sticky.
The valve is blocked.
The lamp is defective.
Temperature is set incor‐
rectly.
Large quantities of food to
be frozen were put in at the
same time.
The room temperature is too
high.
Food placed in the appli‐
ance was too warm.
The lid is not closed proper‐
ly.
The lid is not closed correct‐
ly or the gasket is deformed/
dirty.
The water drainage plug is
not correctly positioned.
Temperature is set incor‐
rectly.
The temperature regulator is
not set correctly.
The lid is not closed correct‐
ly.
Solution
Contact the nearest Author‐
ized Service Centre.
Arrange the packages in the
right way, see the sticker in
the appliance.
Eliminate excess frost.
Clean the lid gaskets.
Check the valve.
Refer to "Replacing the
lamp".
Refer to "Operation" chap‐
ter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food to cool to room
temperature before storing.
Check if the lid closes well
and the gaskets are undam‐
aged and clean.
Refer to "Opening and clos‐
ing the lid".
Position the water drainage
plug in the correct way.
Refer to "Operation" chap‐
ter.
Set a higher/lower tempera‐
ture.
Refer to "Opening and clos‐
ing the lid".