Eneral Notes On Safety; I Ncorrect Use; Rior To Taking The Machine Into Service; T Aking The Machine Into Service - SUHNER ABRASIVE LSA 79 Dossier Technique

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
1. N
1.1 g

enerAl notes on sAfety

This operation manual is applicable for the machine LSA
79.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The machines are intended for the purpose of cutting,
roughing and brushing of metal and stone materials.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Translations of the «EG-Koformitätserklärung (Original)».
Otto Suhner GmbH, Trottäcker 50, D-79713 Bad Säckin-
gen, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side) com-
plies with the requirements under the Directive 2006/42/
EG. Applied standards: EN ISO 12100, EN ISO 11148.
Document Agent: T. Fischer. D-Bad Säckingen, 10/2019.
T. Fischer/Managing Division manager
2. C
2.1 P

rior to tAKing the mAchine into serVice

Use oiled compressed air (see also air quality un-
der section 2.3). Observe national regulations.
2.1.1 f
itting of hose couPling
Fitting of hose coupling inside diameter min. 4.5mm
(available as optional accessory, item no. 90805100).
16
S
oTES oN
aFETy
ommISSIoNINg
2.2 t
AKing the mAchine into serVice
Before connecting the tool to the com-
pressed air supply set the rotary valve to
the «OFF» position! The tool may be swit-
ched on only when the lock and attachment have been
installed correctly.
2.2.1 t
/t
urn on
urn off
Switch on the tool by turning in the direction of the arrow
to the stop. Turn back to switch off the tool.
Before cutting off the compressed air supply, al-
ways set the machine to the «OFF» position so
that the tool cannot be reactivated inadvertently.
2.3 r

Ating dAtA

Pressure
Power output
Air consumption full load
Air consumption at idling
Setting oiler idle
No-load speed
Max. wheel diameter
Max. chuck diameter
Sound pressure level EN ISO 15744 71.9dB(A), K=3dB(A)
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight with hose
2.4 o

PerAting conditions

Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3.
haNDLINg
3.1 t
ools
Use only clean tools!
max. 6.3bar
110W
0.29m
/min
3
0.31m
/min
3
about 1-2 drops/min
77000min
-1
10mm
3mm / 1/8"
1.54m/s
, K=0.65m/s
2
2
2/4/4
0.310kg
/ o
PERaTIoN

Publicité

Table des Matières
loading

Table des Matières