Lelit PS21 Mode D'emploi page 4

COMPONENTS:
1. Safety cap
2. Wand seat
3. Iron button with red led
4. Boiler button with red led
5. Low water light indicator
6. Iron plate temperature regulating knob
7. Steam button
USER INSTRUCTIONS:
1. Remove the ironing machine from its packing and make sure all packing parts have been taken off
(including the protection bags). Lay the machine on a flat and steady surface fitted to support it next to a
wall socket (max. mt. 1,5).
2. It is recommended to lay the iron on the supplied pad.
3. Insert in the right seat (2) the supplied wand to hold the hose up and hook it with the spring up to the
iron-boiler connecting wire.
4. Unscrew the safety cap (1) and let the internal air out. Fill the boiler with max. 1,1 litres of water
Use a funnel and make sure you do not overfill the tank.
5. Close the safety cap (1).
6. Insert the plug into the main supply point; switch on boiler (4) and iron button (3). If the two buttons
come on, iron and boiler are working.
7. Turn the iron plate's temperature regulating knob (6) to the position "cotton °°°" (indicated on the iron
knob).
8. Wait that the boiler button's red light (4) goes off (it takes about 10 minutes). While ironing, the boiler
button's red light (4) normally comes on every now and again.
9. The machine is ready for use.
10. Push the steam button (7).
11. In case the steam stops during ironing and the low water light indicator (5) comes on, it means that
there is not enough water in the tank. To start ironing again, switch off the boiler button (4); press the
steam iron button (7) to ensure there is no more steam in the boiler, switch off the iron button (3),
slowly open the pressure cap (1), disconnect the plug and refill to the required level. After a couple of
minutes fill the boiler with possibly warm water.
12. When you first press the steam button you might notice a decrease in pressure. In order to have plenty
of steam wait till the boiler switch indicator light (4) goes off.
CAUTION:
Do not leave the machine unattended while the plug is connected to the socket.
-
The iron reaches very high temperatures and it keeps being very hot even 15 minutes after it's been
-
switching off. Be careful not to burn yourself.
For complete safety, before filling the boiler, please disconnect the plug.
-
While using the machine and 15 minutes afterwards the iron plate has very dangerous temperature – do
-
not touch it.
While using the machine, never unscrew or remove the cap while under pressure (1). Before removing it,
-
make sure that it does not release steam anymore from the iron.
The machine has a special heating element. Only qualified technician should replace it.
-
The safety cap (1) must be replaced with original parts only.
-
PLEASE NOTE:
The use of normal tap water is recommended. In order to clean the boiler and remove limestone, rinse it
internally (every 15-20 litres of water used or every month) only with tap water.
Pag. 4
All manuals and user guides at all-guides.com
English