Worx WG401E Mode D'emploi page 12

• Clean the cutting roller (12).
• Clean and grease the bearings.
• Reassemble the individual parts in the
reverse sequence.
If the machine should happen to fail despite
the care taken in manufacture and testing,
repair should be carried out by an authorized
customer services agent.
mAInTEnAnCE
WARNING! Before any work on the
machine itself, pull the mains plug.
For safe and proper working, always keep the
machine and the ventilation slots clean.
The shredder should not be cleaned with high
pressure cleaners or running water.
The tightness of the attachment screws for the
transport stand should be checked from time
to time.
The cutting roller (12) and the pressure plate
(11) have a life expectancy of several years
under normal usage and when adjustment
according to instructions.
Before storing the machine, remove the cutting
roller (as described in the Section "Replacing
the Cutting Roller/Pressure Plate") and clean.
12
Then treat the cutting roller with preservation
spray and grease the bearings.
EnVIronmEnT ProTECTIon
This product has been marked with a
symbol relating to removing electric
and electronic waste. This means
that this product shall not be discarded with
household waste but that it shall be returned
to a collection system which conforms to the
European Directive 2002/96/CE. It will then
be recycled or dismantled in order to reduce
the impact on the environment. Electric and
electronic equipment can be hazardous for the
environment and for human health since they
contain hazardous substances.
Silent shredder
All manuals and user guides at all-guides.com
PLuG rEPLACEmEnT
(uk & IrELAnD onLy)
If you need to replace the fitted plug then
follow the instructions below.
IMPORTANT
The wires in the mains lead are colored in
accordance with the following code:
Blue = Neutral
Brown = Live
As the colors of the wires in the electrical cord
of this appliance may not correspond with the
colored markings identifying the terminals
in your plug, proceed as follows. The wire
which is colored blue must be connected to
the terminal which is marked with N. The wire
which is colored brown must be connected to
the terminal which is marked with L.
plug. Only fit an approved 13Amp BS1363/A
plug and the correct rated fuse.
NOTE: If a moulded plug is fitted and has to
be removed take great care in disposing of the
plug and severed cable, it must be destroyed
to prevent engaging into a socket.
WARNING! Never connect live or
neutral wires to the earth terminal of the
13
En