Midwest ConTour 560-24 Consignes D'assemblage

Assembly Instructions for Model Numbers 560-24, 562-30, 564-36, 566-42, 568-48
IMPORTANT INFORMATION
Remove collar, tags, and leads from pet before placing it in the pen to prevent possible entanglement.
Unwrap and remove all parts from the box. Keep the box and packing material until the product is assembled. In case of return or
exchange, failure to return product in similar condition as received could result in limited reimbursement. Please save sales
receipt as proof of purchase for warranty purposes. Check to ensure you have all the parts below. If you discover any parts are
missing, immediately call our toll-free service helpline at 1-800-428-8560 (Monday - Friday 9 a.m. to 4 p.m. EST) or email
customer service at info@midwesthomes4pets.com.
Parts Include: Exercise Pen (8 connected panels), 4 Ground Anchors, and 4 Snaps
ASSEMBLY INSTRUCTIONS
1. Remove contents from the carton. Locate the exercise
pen, ground anchors, and snaps.
Configure the pen and connect the two ends with snaps.
For best results, place snaps at the top and bottom
between the two closely spaced wires. Space the
remaining two snaps evenly along the middle wires.
Note: The pen can be moved and
reconfigured after it has been assembled.
2.
For added safety when used outdoors, install a ground
anchor at the bottom right corner of the door panel. Then
install the remaining anchors, spacing them evenly
around the perimeter of the pen.
To Open:
Disengage the slide-bolt latch. Grab the wire in the
center of the door and lift the door upward so the
notch clears the LapLock, then swing open.
To Close:
Swing the door back toward the pen. Grab the wire in
the center of the door, lift the door upward, and push
the door firmly against pen before lowering, securing
the door's far right vertical wire behind the LapLock.
Engage the slide-bolt latch.
Exercise Pen
with Door
800-428-8560
midwesthomes4pets.com
P.O. Box 1031
Muncie, Indiana 47308
LapLock
1