ELAC Vertex III Serie Mode D'emploi page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Soundbar Connection
After choosing the position of the soundbar, do the following to avoid damaging the soundbar:
Ensure your equipment is turned off before connecting the soundbar.
Use appropriate gauge wires (minimum of 16 gauge wire for runs up to 25 feet).
Connect the left, center and right channel output terminals of your audio source to the appropriate
soundbar binding posts as shown in Fig.4.
Make sure wire polarity is connected correctly. Most speaker cables are coded for ease of use. Make
sure positive (red) connection on the audio source terminal is connected to the positive (red) on your
soundbar. Follow the same instructions for the negative side. Strip off approximately 1/2"of the insulation
from the ends of the speaker cable, twist the bare strands and insert into the binding post.
Check to ensure positive and negative wires are not touching each other once they're connected to the
soundbar terminals. See Fig.4.
Installing and Removing the Grill
The mesh grill of your passive soundbar is designed to be removable if desired. To remove it, hold the top or
bottom edges of the grill and pull gently. To install the grill, align the edges of the grills with the edges of the
soundbar. The grill will be positioned and hold in place by the magnets incorporated in the grill.
ELAC SB-VJ41L / SB-VJ41S PASSIVE SOUNDBAR | www.elac.com | Page 4
View from the back of passive soundbar
Right
Center
Channel
Channel
Terminals
Terminals
Audio Source Output Terminals
Fig.4
Left
Channel
Terminals

Publicité

Table des Matières
loading

Produits Connexes pour ELAC Vertex III Serie

Ce manuel est également adapté pour:

Sb-vj41lSb-vj41s

Table des Matières