Honeywell Home evohome HR91 Guide Rapide

evohome
HR91
EN N L
FR D E
ES I T
3
a
M30 x 1.5mm
5
2 x AA LR6
evohome
1. SETTINGS
Press and hold
for 3 seconds.
2. Press the green tick
3. ADD ZONE.
Press
4. Type a name for the new zone
and press the green tick
5. Press RADIATOR VALVE.
6. If you want to control the zone
temperature with the evohome
Controller (which needs to be
located in that zone) press
YES, otherwise press NO.
1
2
1
b
RAV
1
RAVL
2
RA
6
GREEN (5 SEC)
GROEN (5 SEC)
VERTE (5 SEC)
GRÜN (5 SEK)
VERDE (5 SEG)
VERDE (5 SEC)
HR91
7. Press the binding
button for 5 secs.
8. The LED will flash
AMBER for up to
2 mins whilst binding.
9. Successful binding is
confirmed by LED
showing permanent
GREEN for 5 secs.
2
4
Danfoss
7
e v o h o m e
10. You should receive a
SUCCESS
evohome Controller (if not
5 SEC
go back and re-bind).
11. Either press the green tick
2 MIN
to add another radiator to the
zone or press the red cross
another radiator to the zone.
You must repeat these steps
5 SEC
for each radiator controller.
2
1
1
2
evohome
E N
evohome
message on the
if you don't need to add
N L
F R
D E
E S
I T