Canarm Easy Connect Mode D'installation

SAFETY PRECAUTIONS:
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE. DO NOT REMOVE
INSULATION FROM FIXTURE.
2. WIRING SUPPLIES AS REQUIRED BY LOCAL ELECTRICAL CODE.
3. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY
A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
4. CAUTION – RISK OF FIRE. CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH
CIRCUIT CONDUCTOR.
5. TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH
A CLEAN, SOFT CLOTH.
NOTE: Product may not look exactly as shown in figures.
INSTALLATION:
Electrical box screws
Easy Connect
mounting
bracket
Electrical
Box
White
(Neutral)
Black (Live) Green (Ground)
Option 1
Green
(Ground)
Option 2
Jumper Wire
(Neutral)
Black (Live)
Green
Jumper Wire
(Ground)
EASY CONNECT®
INSTALLATION INSTRUCTIONS
QUESTIONS OR CONCERNS CONTACT AT:
1-800-265-1833 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
!
SAVE THESE INSTRUCTIONS
1.
Attach easy connect
mounting bracket to
electrical box with electrical
box screws
(not included).
2.
Option 1: Connect
(push) electrical wires from
electric box
(house wiring) into correct
(N)
inserts.
White
(Neutral)
(L)
Black
(Live)
Option 2: For multiple green
(ground), black (live) and
white (neutral) wires joined
in the electrical box (house
(N)
wiring), attach a single
White
"green" , "black" and "white"
jumper wire before
connecting. Strip 7mm from
(L)
the 6" jumper wires (AWG
12-24) supplied. Then
connect (push) wires into the
correct inserts.
Tel: (613) 342-5424, Fax: (800) 263-4598
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
(N)
White
(Neutral)
Green
(Ground)
Fixture
Star
Washer
Bulb
Fiber
washer
Finial
3.
(L)
Connect (push) electrical
Black (Live)
wires from fixture into correct
inserts.
4.
Once connections of wires
are completed, carefully tuck
wires and wire nuts into the
electrical box making sure no
bare wire (on the black and
white) is visible at the wire nuts.
5.
Tuck electrical wires into
Stud
electrical box and position
fixture over studs on mounting
bracket assembly. Secure fixture
Cap
in place with star washers and
Nut
cap nuts.
6.
Attach the stem to the
fixture.
7.
Install proper bulb type and
wattage (not included).
Stem
8.
Secure the glass in place
using the fiber washer, hex nut
Glass
and finial.
Hex Nut
IOL350
02/18