Publicité
Liens rapides
Publicité
Sommaire des Matières pour 808 NRG GLO SP251
- Page 1 Q u i c k S t a r t G u i d e SP251 QSG 00...
- Page 2 Getting to know Bluetooth Bluetooth wireless is a quick and easy way to connect a smartphone to a speaker or a headset. There are basically two steps to making Bluetooth work. “Hi. i’m a PAIRING: phone.” two devices get “Hi phone.
- Page 3 Step 1: unpack Make sure the following items came in this package. Your speaker cable...
- Page 4 Step 2: charge the NrG GLO Before you start using the HEX NRG GLO speaker for the first time, it’s a good idea to charge it completely. Speaker To charge the speaker: back Plug the included USB cable into the Charge jack on the back of the speaker.
- Page 5 Step 3: turn on Press and hold the Speaker Power/Pair button on front the front of the speaker. The power up tone sounds and the indicator light on the front of the speaker starts blinking. After a few seconds, the speaker goes to Bluetooth pairing mode to set up with your smartphone.
- Page 6 Step 4: Pair + connect Enable Bluetooth on your smartphone or other device. Make sure the indicator light on the front of the Speaker speaker is blinking rapidly. front (If it isn’t, give a short press on the Power/Pair button. The speaker gives an audio signal.) If you’ve previously paired your phone or other Bluetooth device...
- Page 7 Choose 808 Hex NRG GLO from the pairing options on your smartphone. (If it’s not in the list, choose “Scan” from your phone’s Bluetooth menu.) The speaker gives an audio signal when it’s finished pairing and connecting to your smartphone. The indicator light on the front of the speaker turns solid blue.
- Page 8 Step 4: Play music Set your device’s volume for music to 75%. Note: This is to make sure the sound from the speaker isn’t too loud when you start streaming. Start playing music or other audio on your device. Within seconds, the speaker starts streaming the audio wirelessly via Bluetooth.
- Page 9 Step 5: Make it Glow! Press the Glow button on the front of the speaker Speaker to activate the light ring front around the top of the speaker. Keep pressing the Glow button to cycle through the five light modes. Party Mode: The light ring pulses to the beat of your music (you might need to turn it up!).
- Page 10 using the aux in input Use a 3.5mm audio cable Speaker (not included) to connect back the audio output from your device to the Aux In audio input on the speaker’s back panel. The speaker automatically switches to the Aux In audio, and the pairing indicator on the front of the speaker turns white.
- Page 11 tour of the speaker Power/Pair button turns the speaker on and off and puts the speaker into pairing mode to connect to a Pairing new Bluetooth device, indicator like a smartphone. Press and hold to turn on/ off. A short press enters pairing mode. Pairing indicator shows the Bluetooth status of the speaker: • fast blinking blue while pairing...
- Page 12 Glow button activates the light ring around the top of the speaker. Keep pressing it to cycle through the five light modes: Party Mode, Breath Mode, Chase Mode, Solid Light, Dimmed Solid Light, and Off. Charging indicator shows the charging status of the speaker: • solid red while charging charging indicator...
- Page 13 Information importante Important Information RF Exposure Warning This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for pour 808 for 808 SP251 SP251 this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
- Page 14 Cet équipement doit être installé et utilisé conformément aux instructions qui l’accompagnent et l’antenne ou les antennes Este equipo debe instalarse u operarse de acuerdo con las instrucciones suministradas. La(antena(s) utilizada(s) con este para 808 utilisé(e)s pour cet émetteur doivent être installées de façon à assurer un espacement d’au moins 20 cm par rapport à toute transmisor debe(n) instalarse de modo de proporcionar una distancia de separación mínima de 20 cm de todas las personas...