Pot Detection - Fabita ordine Instructions

D_ Power level_ +_
D
desired power level by pressing the "-" and "+" symbols, with the
default power level set at P1;
E_ Pause end Recall_
E
functions. If you leave the function on pause for 5 mins the
product will switch off automatically.
F_ On/Off_
F
automatically after 30s. The fan will continue to work for 60s after
the product is switched off.

POT DETECTION

This cooktop is fitted with an interactive control system that
makes it very easy and comfortable to use. When a pot is removed
from an active cooking zone, the corresponding display shows the
flashing symbol. The symbol disappears if the pot is replaced on
the zone and the cooking starts again according to the previously
set regulations. The symbol also appears on one of the cooking
zones displays when:
1.
2.
RESIDUAL HEAT «H»
If the temperature of the cooking zone is still high (over 50°) after
it has been switched off, the relative display will indicate the «H»
symbol (residual heat). The symbol will only switch off when the
burn risk in no longer present.
ADVISE ON ENERGY SAVING
•
•
17
If the product is in standby mode, it will switch off
The recipient being used is not suitable for induction cooking.
The diameter of the recipient used is inferior to that allowed
by the appliance.
Always use the lid corresponding to each pot. When you cook
without the lid, the energy consumption is much higher. Use
a glass lid in order to see inside without lifting it.
Use flat base vessels. If the base is not flat, the energy
consumption is higher. The base diameter of the vessels must
correspond to the size of the cooking zone. Note: the vessels
manufacturers indicate, generally, the upper diameter of the
vessel, which is always larger than the base.
(increases power)_ just select the
activate and deactivate the