Typical Installation - Vortex VX 1982 35.5 Manuel D'installation

VX 1982 35.5
Description:
The VX 1982 35.5 Vortex used on mortise type of installation, requiring a filtered
and regulated DC Power source of correct voltage to attract the Armature plate and
when external pressure is applied to break that hold, the pivoting pin head fitted
into the Mechanical Electro Magnet slot holes will initiate a second locking attempt
from the upward movement of the magnet within the lock body to drag out the six
ball bearings to clasp firmly on the pivoting pin head with a superb holding force of
15 000 N (~1 500 Kgf) and when power is removed the Mechanical Electro Magnet
would release its hold on the Armature plate and retract to its original position as
the bearing would roll back to release the clasp on the pivoting pin
The VX 1982 35.5 operates on 24 VDC or 12VDC
switch sensor for remote lock monitoring status (Normally Open) on two non
polarity YELLOW output wires, and a remote door monitoring status (Normally
Open) on two non polarity BLUE output wires. The VX 1982 35.5 consists of an
EARLY WARNING ALARM output C/NC/NO, Brown/White/Grey and a built-in
3
buzzer , to initiate warning before attempted break-in.
The DC output of the power supply must NOT be connected to earth ground, but
isolated to prevent shock and possible damage to the unit.
Wiring and Power Input 24 VDC or 12 VDC:
Wiring must be connected correctly before on a 24 VDC power source is supplied to Vortex to
prevent damage to the unit.
1
– 12 VDC is not authorized for exit doors
2
– Even a preload of 1 000N is applied on the system
3
– Buzzer can be disabled with the dip switch 4
- INSTALLATION
v.3
2
.
1
with two built-in SPST reed
DSS wiring: BLUE
(Normally Open) BLUE
LSS wiring: YELLOW
(Normally Open) YELLOW
Buzzer OFF
Buzzer ON
+
(NO)
EW Wiring: GREY
WHITE
(NC)
BROWN (C)
12VDC SETTING 24VDC SETTING
0.4A max 0.2A max
1

Typical installation 1:

Pivoting Pin Assembly:
Permanent magnet
Applled drop-wise of provided
threadlockrs glue to the thread
of the security sleeve nut to
prevent loosening.
NOTE: Make sure to have the rubber washer mount sandwich in
between flat washer for absorbing shock and obtaining the required
strength.
2