Beacon TSL VISOR Instructions D'installation

TSL VISOR INSTALLATION INSTRUCTIONS. IMPORTANT
INSTALLATION INSTRUCTIONS
TSL VISOR
WARNING! Fixtures must be grounded and installed in accordance with the National Electrical Code and all local codes.
Failure to do so may increase the RISK OF PERSONAL INJURY, PROPERTY DAMAGE, FIRE AND DEATH. Install and
use so fixture failures do not cause a hazard and use only in environments for which the product is specifically marked.
WARNING! This product contains chemicals known to the State of California to cause cancer, birth defects, and/or other
reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
CAUTION! Follow ALL luminaire recommendations, product markings, instructions, restrictions and warnings regarding
luminaire operation and burning position. Luminaire label shows electrical and environmental requirements and
restrictions.
All electrical work must be done by a qualified electrician.
Turn off electric power to all affected circuits and allow to cool before servicing.
A regularly scheduled maintenance program should be established to retain optimum light output and reduce heat
retention. Dusting with a soft, clean, dry cloth is normally sufficient for the optical system. Any accumulation of dust or dirt
should be removed regularly.
Carefully read these instructions before installing product. If you do not understand these instructions, before starting any
work, contact your distributor or Lightingtechsupport@currentlighting.com or (864) 678-1000
Give instructions to facility owner/manager for future reference.
TOOLS REQUIRED:
•
7mm HEX DRIVE
•
PHILLIPS STYLE SCREWDRIVER
Installation Steps:
•
Line up the visor to the front face of the
casting as shown.
•
Install the three short screws to the
threaded holes in the casting and tighten
using Phillips drive.
•
Install the two remaining long screws,
with flat washers on them, through the
visor wall and through the casting wall.
•
Place the nuts on these two screws and
tighten using 7mm hex drive.
Current Lighting • 701 Millennium Boulevard • Greenville, SC 29607 • Phone: 864-678-1000
©2022 HLI Solutions, Inc. All Rights Reserved. Information and specifications subject to change without notice.
All values are design or typical values when measured under labarotory conditions.
SAFEGUARDS
SAVE THESE INSTRUCTIONS.
READ THOROUGHLY BEFORE INSTALLATION
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS.
93141867 Rev B - Page 1 of 2
www.beaconproducts.com