Vente Unique A158 Instructions D'utilisation page 19

Method of usage
Safety and warning
4.Turn off the power, end the massage
1.During the massage process, press the red power switch to immediately turn
off the chair, the chair and massage hand automatic reset.
2.Massage time is up (20 minutes), stop all massage, the massage hand reset.
3.After the reset, the chair cut off the power.
Diagram of the power switch position
5.Method of calf flip
1.When using the calf flip function, first flip the calf to the intersection with the
calf beam tube (the stuck cannot be rotated)Such as (Figure 1).
2.then pull the calf forward 5cm and then flip down (Figure 2), when the calf is
turned back, the opposite.
Figure 1
6.Moving method
· When carrying the massage chair, you need two people, one lift it by back of the
back cover frame and other people carry the chair calf frame, lifted massage
chair at the same time (PLEASE NOTE: Do not carry armrest to move the chair, the
chair is too heavy carried by armrest. If the armrest damage, the chair will drop to
cause the people injured).
Unplug the power cord
Figure 2
Method of usage
Safety and warning
7.Floor Protection
· Put the heavy massage chairs on the wood floor for a may damage the floor,
so please place a carpet or other object to avoid this damage.
Caution: Do not use the caster to move the chair on the uneven ground and the
small space. If you want to move, you need two people, one lift it by back of the
back cover frame and other people carry the chair calf frame, lifted massage chair
at the same time (PLEASE NOTE: Do not carry armrest to move the chair, the chair
is too heavy carried by armrest. If the armrest damage, the chair will drop to cause
the people injured).
8.Method of movement
•Make sure that all wires are far above the ground, tilt the backrest backward to
a certain degree (with the gravity center resting on the wheels), push the chair
forward or backward with your hands and finally resume the chair to the normal
position in a slow and gentle manner.
During movement you must turn off the power first and then
unplug the power cord and the controller cord.
Note
．
25