Uberhaus Design 38115071 Guide De L'utilisateur page 7

Fig.4-1: Insert the junction bar (D) into the decorative slot 1(C1) and decorative slot 2 (C2), and secure
with bolt (CC) and flat washer (BB).
Fig.5: Install the plastic rings (EE) into the runner of side beam 1 (B1) and side beam 2 (B2), 12 plastic
rings for each runner.
Fig.6: Insert the beam junction (F) into back beam 1 (E1) and beam 2 (E2) and secure with bolt (CC),
and flat washer (BB).Install the middle beam 1 (G1) and middle beam 2 (G2) in the same way with
back seam1 (E1) and back seam2 (E2).
Fig.7: Use bolts (FF) to install the complete side beam 1(B1) (or side beam 2(B2)) to front post 1 (A1)
and back post2 (A4)(or front post 2(A2) and back post 1(A3))
Fig.8: Install the complete decorative slot to front post with bolt (GG) and flat washer.
Fig.9: Install the corner support (U) to the corner of front post, and secure them with bolt (HH) and bolt
(BB).
Fig.10: Install the complete back beam to back post with bolt (FF).
Fig.11: Use bolt (HH), flat washer (BB) to install the connecting piece 3 (S3) (or install connecting
piece 4(S4)) to edge beam 1(L1)(or edge beam 2(L2)), then install the complete side beam to post 1
(A1)(or post 2(A2))
Fig.12: Using connecting piece 2(S2), bolt (CC), flat washer (BB) to secure the edge beam 1(L1)(or
edge beam 2(L2)) to back seam. Use bolt (CC) and flat washer (BB) to install middle beam mounting
bracket (R) and middle beam to side beam. Install connecting piece 2 (S2) to the bolt of edge beam
1(L1)(or edge beam 2(L2)) s card slot by using bolt (DD) and flat washer (BB), then use a bolt (CC)
and flat washer (BB) to install connecting piece (2) to middle beam.
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn