Attaching Labels; Operation; Cleaning, Care & Maintenance; Troubleshooting - Hofland RDS-57HUS Manuel

Attaching Labels

1. Slide the relevant label into the magnetic label holder.
2. Attach the holder to the side of the appliance.
► Note: If the desired label is not included, simply write the name of the product on the
reverse of one of the labels.

Operation

1. Connect the appliance to the mains power supply.
2. Fill the outer container with approximately 600ml of warm water.
3. Carefully place the inner container into the appliance.
► Note: The inner container must NOT float, even when empty. If the container floats
reduce the amount of water in the outer container.
4. Fill the inner container with hot products (Soup/sausages) max. 4 litres and close the lid.
► Note: If necessary, remove any excess water from the outer container.
5. Set the temperature control. The temperature ranges from 1 (lowest) to 12 (highest).
. Between position1-8 the temperature will flow from 65 to 75 degrees Celcius
. Between position 8-12 the temperature will increase from to max. 85 degrees Celcius
6. The Power light will come on and the kettle will begin to heat up.
► Note: Kettle is not designed to heat food from cold
7. Reduce the temperature to maintain heat levels. To maintain temperature,
We recommend the lowest heat setting possible.
8. Use a suitable implement to remove the contents of the kettle. DO NOT tip the kettle to
remove the contents.
9. To turn the appliance Off, set the Temperature Control to '0'.
WARNING: Never move or carry the appliance when it is switched on or contains hot
liquid.
Cleaning, Care & Maintenance
• Always turn off and disconnect the appliance from the power supply before cleaning.
• Clean any spilt food on the appliance immediately.
• Do not let water stand in the inner layer , which can cause rust.
• Use soapy water and a damp cloth to clean the exterior of the appliance.
• The inner container and lid are machine washable.
• Dry thoroughly after cleaning.
►Note: The lid is hinged in the middle. Lift one half of the lid to access the container.

Troubleshooting

Fault
The unit is not working
Soup not heating up
10
Probable cause
The unit is not switched on
Plug and lead are damaged
Fuse in the plug has blown
Internal wiring fault
Power supply
Insufficient temperature setting
.
Action
Check the unit is plugged in
correctly and switched on
Call a qualified technician
Replace the plug fuse
Call a qualified technician
Check power supply
Increase temperature setting
© Hofland Foodservice 2016