Power Source - AirMan AIRGUN Manuel De L'utilisateur

POWER SOURCE

The air compressor can be powered by both
the Li-ion rechargeable battery and the 12V
cigarette lighter adapter.
CHARGING FROM THE AC
CHARGER PORT ON THE BATTERY
Important! Please charge over 3 hours
before first use.
Remove the battery from the air compressor
by gripping the end of the battery and pulling it
out. The AC charger can be used to charge
the battery directly by connecting the AC charger
to AC charger port on the battery and plugging
the AC charger to a 120V power source. When
the charger's LED lamp changes from red to
green, charging is completed, please remove
the charger.
Warning! Failure to fully charge the battery
will result in shorter life, compromised per-
formance and will void battery warranty.
STEP 1
STEP 2
AC Charger Port
www.my-airman.com
TYPICAL RUN-TIME*
DEVICE
Air Compressor
*REMARK:
1.Typical run-time will vary depending on the
battery level, pressure load during use, and
the operating conditions.
2.High-pressure loading, or excessive back
pressure will result in a shorter run-time
than indicated above.
3.Cold temperature conditions will reduce
battery run-time. We recommend
using the 12V cigarette lighter adapter
pack during cold temperature
operating conditions.
When the operating period per charge is
significantly reduced, it indicates the
battery is worn-out and should be replaced.
12V CIGARETTE LIGHTER ADAPTER PACK
Switching between the battery and 12V ciga-
rette lighter adapter pack
Roll out the 12V cord before use.
Remove the battery from the air
compressor by gripping the end
of the battery and pulling it out.
Slide the 12V adapter pack into the
air compressor until clicks into place.
Make sure that the cord runs through the
small hole at the base of the cable pack.
Connect the 12V car cigarette lighter
adapter to the cigarette lighter socket
in your car.
TYPICAL RUN-TIME*
(5 - 10) minutes
2