Operation And Use - Light-N-Carry LNCBAR Manuel De L'opérateur

CONTENTS
Your Magnetic Lighting Bar Mount includes:
– LNCBAR: 2 parts
– Thumb Screw
– Six Magnets
ASSEMBLY
Your LNCBAR ships in two pieces for ease of shipping. To assemble,
connect the two halves by loosening the thumbscrew and inserting the
portion with the male end into the portion with the female end. Then,
tighten the thumbscrew to ensure the connection is secure – the thumb-
screw requires only hand tightening. Avoid overtightening.
Connect the preferred number of magnets to the bar as needed by
screwing them into the pre-drilled holes on the back of the bar. These
allow the bar to be mounted on metal surfaces, including storage on a
toolbox.

OPERATION AND USE

Your LNCBAR is versatile enough to be used in a wide variety of applica-
tions. With its included magnets, it can be mounted to any ferromagnetic
metal surface. Note that the thickness of the metal surface needs to be
sufficient to hold the bar in place. Make sure you pull the LNCBAR to
judge whether the metal surface will be strong enough to hold the
LNCBAR plus desired attachments.
In addition, its bar end hooks can be expanded to mount across a wide
variety of spans, such as vehicle hoods. Beyond expanding, the bar end
hooks articulate in two ways (rotating on its axis and revolving around a
pivot point as shown on page 4).
3