Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
Step 1: Screw thread bolts #21 into the side panel #1A and #1B, and cross board #2A and #2B
as shown below. Insert gears #20 into cover plate #3, base plate #4 and cross board #2A
and #2B. Note: see illustration below for alignment of gear to hole. Attach cross board #2A to
base plate #4 with gears #20. Attach cross board #2B to cover plate #3 with gears #20.
Attach side panel #1A and #1B to plates #3 and #4 in the same manner.
#2A
#20
#21
Step 2: Attach the top back board #5 to the assembled cabinet with screw #19.
#21
#1A
#21
#2B
#20
#3
#4
#21
#1B
Note: When gear is inserted into
hole, the arrow should point
directly out toward hole that
bolt will be inserted into.
Once bolt is inserted, turn gear
clockwise to lock.
#21
#19
Note: Position top back
board so four dartboard
mounting holes are closer
to the top than bottom of
cabinet.
#5
5
Publicité
Table des Matières
