ASSEMBLY INSTRUCTIONS
1. Using the access hole located at the rear of the
fountain (A), locate the pre-installed tubing. Attach
the tubing to the pump (B). Place pump (B) inside the
fountain body reservoir.
2. Using the access hole located at the rear of the
fountain (A), locate the 4 to 1 connector (D) and drape
it out the rear of the fountain (A). The 4 to 1 connector
(D) should not be submerged. Connect the cord from
the 4 to 1 connector (D) to the transformer (E).
3. To prevent the risk of water loss during operation,
create a drip loop with the light cords as shown. Fill
the water reservoir with enough water to completely
submerge pump (B). Install the pump access door (F).
4. Connect the power cords into an electrical socket to
run the fountain.
1
2
B
3
F
4
3
B
A
C
D
B
E
A
E
A
B
E