FIBER CONNECTOR SAFETY WARNINGS
SAFETY INFORMATION
1. Always wear safety glasses.
2. Isopropyl alcohol is
with water for at least 15 minutes. When using isopropyl alcohol, always assure
proper levels of ventilation. In case of ingestion, consult a physician immediately.
3. Never look directly into a laser light source, point source at a person's eyes, or point
source at
surfaces.
4. When working on a
5. Always dispose of
6. Do not place food or beverages in the vicinity of the work area.
7. Thoroughly wash face and hands after terminating
8. Carefully remove any
area, and dispose of properly.
TIPS AND RECOMMENDATIONS
1. Using isopropyl alcohol, thoroughly clean exposed
from dust, oil, and debris.
2. Do not lay ferrule dust covers on a dirty or dusty surface.
3. Always use proper tools and/or accessories to terminate
TABLE OF CONTENTS
The following instructions will help you quickly install your Leviton Opt-X
use in your equipment cabinet or rack. For detailed information on each step, go to the page number listed below.
Safety and Installation Instructions
Table of Contents
Mounting, Front Door Operation, and Rear Door Operation
Page 2 of 30
and may cause eye irritation. In case of contact with eyes,
link, always turn laser source off, or disconnect completely.
debris properly, preferably using sticky tabs.
debris that may have been stuck to clothing, or left in work
®
HDX High Density System Labeling
and buffer ensuring both are free
and clean connector tips.
®
HDX High Density System Enclosure for
Pg. 2
Pg. 2
Pg. 3
Pg. 3
Pg. 3
Pg. 4
Pg. 5
Pg. 6
Pg. 7
Pg. 8
Pg. 9