Troubleshooting - MALONE Duett Pro V1 Mode D'emploi

Inserting the batteries
When inserting the batteries, make sure to observe the polarity. To do this,
look at the diagrams on the inside of the battery compartments.

TROUBLESHOOTING

Problem
No sound.
The signal strength is
significantly weaker than
with conventional cabling
/ Different guitars are at
different volumes.
Sound increasingly
distorted.
Interferences are
disturbing the sound.
Indicator
The red transmitter LED
does not light up.
The transmitter LED lights
up.
The receiver LEDs light up.
The transmitter LEDs light
up, the receiver LEDs do
not light up.
The receiver LEDs light up.
The receiver LEDs light up.
The signal LEDs light up.
Possible solution
Switch on the transmitter. Make sure charged batteries
are installed correctly.
Is the mute function activated?
Turn up the volume. Make sure that the connection from
the audio outputs to your mixing console or similar is
working.
Make sure that the frequencies on the transmitter and
receiver are set the same.
Compensate for the problem using the GAIN control on
the transmitter and the volume control on the receiver.
The batteries are dead. Change them.
Locate possible sources of interference (other
transmitters, steel reinforcements). Switch off
transmitters that are not needed. Mark "dead spots".
EN
23