Facom CL2.CH1419 Notice D'instructions page 8

Li-Ion batteries :
- FACOM Li-Ion batteries have no ''memory effect''; therefore you do not need to empty them completely before recharging them.
The batteries are fitted with an electronic over-heating or over-current cut-out system.
This state is confirmed by all the LEDs flashing when test button 1 is pressed.
RECOMMENDATION: To prolong battery life and increase performance, completely discharge them once or twice a year, by running the
machine with no load until the motor comes to a complete standstill.
To protect batteries in storage, charge before storing and recharge every six months.
After charging:
- The Facom CL2.CH1419 charger allows leaving the battery in place after charging without damaging it ; a maintenance
current replaces the charging current when the green indicator is lit.
However, we recommend removing the battery once it is charged.
Charge and alarm indicators
Environmental protection:
The batteries must follow the collection and recycling procedure enforced in your area.
FACOM Li-Ion batteries comply with the new European directives RoHS-2002/95/CE
and WEEE-2002/96/CE.
Do not throw the batteries away.
EC statement of compliance:
WE, FACOM S.A.S., 6/8 RUE GUSTAVE EIFFEL - BP 99 - 91 423 MORANGIS CEDEX FRANCE, STATE UNDER OUR LIABILITY THAT
THE FOLLOWING PRODUCTS:
CL2.CH1419 – CHARGER 19,2 V
CL2.BA19 – BATTERY 19,2 V
COMPLY WITH THE PROVISIONS SET OUT IN THE FOLLOWING EUROPEAN DIRECTIVES:
- ''ACCUMULATORS'' DIRECTIVE 2006/66/CE
- ''LOW VOLTAGE'' DIRECTIVE 73/23/CEE AMENDED BY DIRECTIVE 2006/95/CEE
- ''EMC'' DIRECTIVE 89/336/CEE AMENDED BY DIRECTIVE 2004/108/CEE
AND COMPLY WITH THE PROVISIONS SET OUT IN THE FOLLOWING HARMONISED EUROPEAN STANDARDS:
- EN 60745
- EN 55014
- EN 60335
8
by FACOM
DC
by FACOM
DC
20.01.2009
The FACOM Quality Manager