Safety Notice - Kimex Gamme 046 Manuel D'utilisation

Assembly instructions
(Fig. 20)
(Fig. 21)
(Fig.22)
8.Lay the frame on the floor and position
the legs over the sides of the frame.
Use the hand screws to attach the frame to
the legs just little before tighten two sides
of them firmly. (Fig.20+21)
9. When the frame is in the vertical
position, fold the front facing feet of the
legs out. Assembly is completed and the
projection screen will be stable on a flat
surface.(Fig.22)
Assembly instructions

Safety Notice

Misuse of the screen may cause
damage to the screen, or injury
to persons.
Warnin
g
Do not hang things from the
screen or climb on it. Doing so
may cause the screen to fall off
and damage the screen and
Do not climb
cause injury.
on the screen
Note: If the screen is faulty or is damaged in any way. Do not try to repair the projection
screen yourself. Contact customer service to arrange it to be repaired.
The projection screen parts and specifications are subject to change without prior
notice.
10. After using the screen, disassemble
the screen and store it in the box
provided. To disassemble the screen,
implement the assemble procedure in
reverse order.
The projection screen must be set up on a
stable surface where there is sufficient
space. Failure to do so may cause the
screen to fall over causing damage to the
Notice
screen and injury to persons.
After using the projection screen
Disassemble the screen and store it in
the aluminum storage box provided.
This will protect it from dust, dirt and
Warnin
accidental damange.