Bosch 1119 Mode D'emploi page 7

Using the Remote Control
4.3 Remote Control Activa-
tion
Before
i
control will work it will
have to be activated,
using
described below, and
standing in front of the
equipment.
B Move the main switch on the
equipment to the 0 position.
B Keep the "Program" button on the
device pressed and turn the main
switch to position I.
The code "P1" will appear on the
control panel display.
B Release the "Program" button and
press the
until the code "P3" appears.
The device is now in the "remote
control activation position" with the
code "P3" displayed.
B Keep the "Program" button pressed
for several seconds until the code
"99" appears on the display.
B Point the remote control at the
equipment and simultaneously press
6
the remote
the procedure
on the control panel
the buttons
remote control (Fig. 7).
Fig. 7 Remote control activation
B Keep the buttons
pressed until the control panel
display stops flashing and the code
"00" appears.
B Move the main switch to the 0
position.
The remote control is now active.
4.4 Hot Water Temperature
Adjustment by Remote
Control
B Press the buttons
the remote control (Fig. 8, pos. 2)
until the required temperature (in
degrees centigrade) appears on the
remote control display (Fig. 8, pos.
1).
B When the required temperature is
defined, turn on the hot water tap.
and on the
and
or on
6 720 607 740