Publicité
Les langues disponibles
Les langues disponibles
INSTALL INSTRUCTIONS
VERSARAC
Installation Instructions
STEP 1
Unpack boxes to verify you've received
all proper components for the rack you've
purchased.
STEP 2
Identify parts by matching them to the
parts list provided. You may receive extra
hardware with each unit. If you do not have
all parts, please call us immediately.
STEP 3
Determine where you want to install
your VERSARAC and examine the ceiling
structure. Do not install more than one
VERSARAC unit on any two overhead
supports.
STEP 4
Locate the ceiling joists (the horizontal
studs or beams that run along the ceiling
structure). If your garage has an open ceiling,
you will see the supports. If your garage has
finished drywall on the ceiling, use a stud
finder to locate both sides of the ceiling
joists. Use a pencil to mark both sides of the
ceiling joist, and the center of the ceiling
joist. If you have steel beams, you will not
be able to install VersaRac. VersaRac is not
intended for steel framed homes. Do
not attempt to mount to steel beams.
STEP 5
Place a ceiling mount angle on the
ceiling so that the center of the holes
in the mounting angle are lined up
with the center of the joist. Mark a hole
in the narrow part of the keyhole, making
sure the mark is in the center of the ceiling
mount angle. You need to mark 2 holes per
bracket. See figure 1.
Figure 1
?
need more information
try
STEP 6
Use the 3/16" drill bit to drill pilot holes for the long lag bolts, 8 holes total for the 4 brackets.
Use the diagram in Step 8 to determine the locations of the lag bolts in the ceiling.
STEP 7
Install the ceiling mount angle into the joists using ¼" x 3" lag bolts and washers provided.
Place a washer between the bolt head and the ceiling mount angle. Lag bolts must be
installed at least 1.75" deep into solid wood joists. Make sure the lag bolts are tight against
the ceiling but do DO NOT over-tighten the lag bolts. If lag bolts are over-tightened, they
could snap the lag bolt head or strip out the hole.
STEP 8
Use the diagram below to determine the locations of the ceiling mounting angles.
In-Line View
Wood Ceiling Joist
Cross Section View
When placing the vertical angle
posts across from each other,
ensure they are facing the same
direction. Place the vertical posts
so that the outside dimensions
match the appropriate frame.
STEP 9
Identify the height from the ceiling where you would like the bottom of the shelf to be.
Remember that your storage space will be 3" shorter than this dimension due to the height
of the bottom shelf beam.
, WWW.NEWAGEPRODUCTS.COM
This measurement depends on the rack you are installing - either 48" or 96".
Ceiling
Mounting
Angles
When installing the Ceiling Mounting Angles on
to a ceiling joist, make sure you measure from the
same end of the bracket. This ensures the holes are
positioned correctly.
Vertical
Angle Posts
Ceiling Joists
Ceiling
Mounting
Angles
48"+/-
Vertical
Angle Posts
1 877 306 8930
or
for answers to commonly asked questions
48" or 96"
.
Publicité
