Beamz Pro HZ3000 Mode D'emploi page 6

The unit provides 3 pin XLR connectors for DMX connection. The diagram below indicates pin assignment information.
Caution: At the last fixture, you must close the DMX line with a terminating resistor. Take an XLR connector and solder a 120 Ohm resistor
between signal (-) and signal (+) and connect it to the DMX output of the last fixture in the line.
DMX CHANNELS
Channel Function
1 Haze
2 Fan
We recommend a frequent cleaning of the unit.
Noted: There are no serviceable parts inside the unit except for the fuse. Repairs and service operations are only to be carried out by authorized
dealers.
CAUTION! Disconnect the mains plug from the wall socket before starting any maintenance work!
• Ensure the fluid do not become contaminated.
• Ensure the air vents are not clogged by dust. If necessary remove the dust.
• Ensure that the unit can not get overheated.
• Do not run the unit without any fluid, as the pump will run dry.
• Wipe up spilled fluid immediately. Moisture and fluid can permanently damage the electrical components of the unit.
For cleaning the surface of the unit use a suitable, solvent-free cleaner.
•
• It is recommended to run the unit on a monthly basis in order to achieve best performance and output condition.
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Value Description
000-005 Haze off
006-127 Haze output low
128-255 Haze output high
000-005 Fan speed 20%
006-255 Fan speed 21 - 100%
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.