Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Determine the correct diameter of bolt to
2
use by carefully trying one bolt each from
Bags 1 - 4 of the hardware kit. Do not force
any of the bolts – if you feel resistance stop
immediately and try a smaller diameter bolt.
Attach the arms to the back of your display
3
using the bolts identified in Steps 1 and 2
along with the corresponding Lock Washer
(C, F, I, or L).
5
A) If you are using the M4, M5, or M6 bolts
(Bags 1, 2, and 3 respectively), you will also
need to use the M6 Washers (O).
B) If you are using one of the longer bolts on
a display with a curved or recessed back,
you will also use a spacer (M or N). Use the
smaller spacer (M) for M4 and M5 bolts and
the large spacer (N) for M6 and M8 bolts.
Make sure all screws are secure, but do not
4
over-tighten them.
E
Tip
Use a longer bolt and spacer for
displays with curved or recessed
backs. Do not use the M6 Washer (O)
if you are using the M8 Bolts (J or K).
4 Mounting and adjusting
With the help of another person, carefully
1
lift your display and place it on mount.
Place the display in the middle of the
mount, and do not release the display until
the mounting arms have securely hooked
onto the crossbars.
5
Move the safety tab located on each arm
2
into position to avoid having the display
accidentally lifted from the mount. This
MUST be done in order to secure the
display to the mount.
D
Note
A cotter pin (included) is used to
secure the arm into position OR
a padlock (not included) can be
inserted into one of the tabs to help
prevent theft of your display.
The cable management clips can be used to
3
keep your power cord and other cables in
order.
Side-to-side and front-to-back adjustments
4
can be made by firmly grasping your display
and carefully moving it to the desired
position.
6
7
6
7
Publicité
Table des Matières
