Parts List; Base Installation Guide - Rotec AQUARIUS 200M 2.0 Manuel De L'utilisateur

Parts List

All electronics and components that need to be installed are placed in boxes under the base or
attached to the frame. Before discarding the packing materials, ensure that all the parts are
accounted for.
x1 x1 x1
3 AAA batteries
for remote control
Remote Control Power Supply AC Power Cord
（29V 2.0A）
x1
x1
x1
AQUARIUS 200M
Owner
Adjustable Bed Base
All Rights Reserved.
(single bed only)
Bluetooth Receiver Synchronisation Owner's Manual
Cord
Not Included
9V
9V
2 9V batteries for the device
in case of power failure
NOTE: To avoid damage to the base, always open the carton while the base is in the
flat position.
02
x1
x1 x6
3"+3"+6"
Mattress Adjustable Legs Device in case of
Retainer Ba
s Manual '
Rev 3.0 03/2022

Base Installation Guide

Two people are required to set up the adjustable bed base.
1.
9V
9V
（Not included ）
Power Failure
2.
3.
x1
3 AAA batteries
for remote control
Remote Control
x1
9V 9V
（ ）
Not included
Device in case of
Power Failure
Open the box, take out all the packing components.
Remove the base from the box. Make sure the floor is clean. Lay the base flat on the floor.
Install legs and tighten by hand.
x1
x1 x1 x6
3"+3"+6"
Power Supply AC Power Cord Mattress Retainer Bar Adjustable Legs
（29V 2.0A)
x1 x1 x1
AQUARIUS 200M
Owner s Manual '
Adjustable Bed Base
Rev 3.0 03/2022
All Rights Reserved.
(single bed only)
Bluetooth Receiver Synchronisation Owner's Manual
Cord
03