Grandstream GVC3210 Guide D'installation Rapide page 7

USING THE GVC3210 REMOTE CONTROL:
LED Indicator
Back
Home
Shortcut Keys
Volume Down
OK
Zoom Out
PIP
Send/Answer/Add
Party Into Conference
Backspace
Standard Keypad
* / Record
1. Open the battery cover on the back of the remote control. Place four
AAA batteries proprely and put the cover back on.
2. When using the GVC3210 for the first time, the remote control should
be paired and connected to it via Bluetooth or infrared connection al-
ready. After the GVC3210 fully boots up, tap on the OK button on the
remote control to initiate the connection. Then the remote control can be
used normally.
Power ON/OFF
Trackpad
Menu
IPVT-Personal Room
Volume Up
Navigation Keys: Up/
Down, Left/Right
Zoom In
Presentation
Camera
End Call / Remove
Party from Conference
# / Information
Mute / DND
~ 9 ~
The remote control has two connection modes:
1. Infrared connection:
Infrared signals are automatically used to connect the remote control to
GVC3210. Users need to keep the two devices in front of each other
without any substantial obstruction in between.
The LED on the remote control is green when using infrared connection
mode.
2. Bluetooth connection:
If the remote control is not paired with the GVC3210 anymore (e.g., a
factory reset is made), press OK button and number 5 button at the same
time for about 4 seconds. This will initiate pairing process on the remote
control and it will be paired and connected to the GVC3210 shortly.
Notes:
1. Users can also download GVC3210 Bluetooth remote control app for
Android™ and install to your Android™ device. This app can be used as
an alternative for the remote control in the GVC3210 package.
2. After the remote control is paired, users could follow the setup wizard
to initiate GVC3210 step-by-step, or skip the setup wizard.
3. For more information about how to use the GVC3210 Bluetooth re-
mote control for Android™, please refer to the GVC3210 user manual:
http://www.grandstream.com/support
~ 10 ~