5/ Troubleshooting - Fagor 60CFP36IX Guide D'utilisation

5/ TROUBLESHOOTING

EN
Fault
Lights on, but motor
does not work
Light does not work,
motor does not work
Oil leakage
The hood is shaking
Insufficient suction
The machine inclines to
one side
Cause
The vent is blocked
The capacitor is damaged
The motor jammed causing
bearing damaged
A bad smell from the motor
which suddenly stops working
Beside the above mentioned, check the following:
Light damaged
Power cord is loose
Damper and the air ventilation
entrance are not tightly sealed
Leakage from the connection of
U-shaped section and cover
The vent is damaged
causes shaking
The motor is not tightly attached
The chimney is
hanged
The distance between the hood
and the gas top is too much
Too much ventilation from open
doors or windows
The fixing screw not tight enough
The mounting screw is not tight
enough
12
Remove the blockage
Replace capacitor
Replace motor
Replace motor
Replace lights
Connect the wires as per
the electric diagram
Take down the Damper and
seal with glue
Take
down and seal
and
Replace the vent
Lock the motor tightly
not tightly
Attach the chimney tightly
Readjust the distance
Choose a new place and re
assemble the machine
Tighten the fixing screw
and make it horizontal
Tighten the mounting screw
and make it horizontal
Solution
U-shaped section