RAB Design LED Serie Instructions D'installation

GAMMA-LED
INSTALLATION INSTRUCTIONS
ELECTRICAL SHOCK HAZARD
WARNING
Disconnect the Electrical supply power at the service panel (fuse or circuit breaker box). Failure to do so could result in serious
injury or death. Only qualified electricians should install this fixture and the installation MUST conform to the Canadian
Electrical Code Part I and all local codes and ordinances. Ensure that only proper tools, materials, and equipment are used to
complete the installation.
SAFETY
•
Proper grounding is required to ensure personal safety.
•
Fixture should be mounted in locations where unauthorized personnel will not readily subject it to tampering.
•
Do not use this equipment for anything other than its intended purpose.
•
Servicing this equipment should be performed by qualified service personnel.
•
Save these instructions.
INSTALLATION
1. Loosen set screws from the fixture slip fit mount
2. Make appropriate wiring connections as per wiring diagram.
3. Carefully place the fixture on a pole with a 2.375 (60.325mm) adapter
CAUTION: Pay attention not to pinch any wiring
4. Tighten set screws to secure fixture
WIRING
•
Check that the line voltage is correct.
•
Connect fixture GROUND (green) wire to power supply GROUND (green) wire.
•
Connect fixture WHITE wire to power supply NEUTRAL wire.
•
Connect fixture BLACK wire to power supply LINE wire
•
If the fixture includes 0-10V dimming functionality, connect GREY and VIOLET
wires to the dimming controller.
RAB DESIGN LIGHTING INC.
READ, UNDERSTAND
before installing the equipment.
21/12/2018
FOLLOW
, and these instructions
Pole
Set screws