Flight Operation; Acrobatic Flight - Carson X4 Quadcopter Nano Spy Manuel D'instructions

FLIgHt operatIon

Model slides (drifts) forwards:
• Remove the speed and gradually move the trim slider of the
nick function on the right-hand remote control lever backwards.
• Move the pitch lever forwards again and check whether the
correction was sufficient, if necessary, move the trim further
backwards.
• Repeat the process until the quadcopter shows no further
tendency to drift forwards.
Model slides (drifts) backwards:
• Proceed as described above, but gradually move
the trim slider of the nick function forwards.
expLanatIon oF controL anD FunctIonS

acrobatIc FLIgHt

The quadcopter enables you to choose between 3 levels of
difficulty. In this case, the copter's agility changes.
Beginner mode:
Press the mode selection button and you will hear 1 beep.
advanced mode:
Press the mode selection button and you will hear 2 beeps.
expert mode:
Press the mode selection button and you will hear 3 beeps.
GB // 26
Calibration function: If the quadcopter always drifts to one side
after launching, place the model on a horizontal surface (table,
floor) and reconnect the 2.4 GHz signal. Then, with the quadcopter
switched on, put the two control levers in the specified position
(illustrated) until the LEDs flash. The calibration procedure is now
complete.