Amplicomms NL 200 Mode D'emploi page 15

1. Press and hold the Power button (4) on
the NL200 until the Status LED (3) lights
up blue.
2. A short time later, the Status LED (3)
flashes blue and the NL200 is registered
on the mobile phone.
Switching the NL200 off
1. Press and hold the Power button (4) on
the NL200 until the Status LED (3) no
longer lights up.
Increasing the volume
1. During a call, press and hold the Volume
Up button (5) until the required volume is
set.
2. An acoustic alert signal is issued on
reaching the maximum volume.
Reducing the volume
1. During a call, press and hold the Volume
Down button (6) until the required
volume is set.
2. An acoustic alert signal is issued on
reaching the minimum volume.
Cancelling the dialling process / Ending a call
1. Press the Power button (4) briefly to
cancel the dialling process and/or end
the call.
0844 800 6503 (Using an UK landline, at the time of going to print: calls cost 6p for connection charge
and then 5p a minute. Mobile costs may vary.
NOTE - due to the wide variety of Bluetooth mobile
phones and other communication devices, when
your device is used with the NL200 it may be
necessary in some cases to end calls from your
handset directly. In some devices ending the call
through the NL200 would stop the connection
of the NL200 with your device, but may not end
the call. To avoid call charges and any
inconvenience please test your device for
compatibility of this function and if required,
end calls from your device directly.
Taking a call
1. Press the Power button (4) briefly to
take a call.
Voice command
You can control the voice command functions
of the mobile phone via the NL200. A condi-
tion for this is that your mobile phone sup-
ports the functions. For more information,
refer to the operating manual provided with
your mobile phone.
1. If the NL200 is in Standby mode, press
Power button (4) briefly.
2. The mobile phone now receives the
voice commands via the microphone in
the NL200.
Using the NL200
15